Valve Assembly Check
1. Verify the gas control knob is in the "ON" position
(Fig. 1)
Fig.1
2. Verify the ON/OFF manual rocker switch is in the "OFF" position
Battery Check
1. Verify that both batteries are good - Test with a multi meter
-The Voltage range for each battery is 1.6v - 1.4v (Receiver)
-All 4 batteries must have a combined voltage of more than 5.2 Volts
-Batteries should be changed annually
Receiver Check
1. If the receiver "beeps" the remote and receiver are programmed
No, reprogram the remote
- Depress the "Learn" button on receiver until an audible "beep"
Fig. 2
is heard, then immediately depress the "ON" button on the transmitter
*If there is another change in "beeps" the code has been set
No, receiver does not "beep"
Action: Replace the receiver
2. Remote and receiver need to be reprogrammed whenever the
batteries are changed
3. The remote and the receiver must have the same security codes
printed on back of the transmitter and receiver.
No, the security codes do not match
Action: Reorder remote control kit
Remote Receiver Wiring Check
(
Remote will not turn fireplace ON
)
1. Move the switch on the receiver to the "ON" position
(Fig. 3)
Fig. 3
Fireplace turns "ON"
- Action: reprogram the remote and receiver.
Fireplace does not turn "ON"
- Action: Verify the wiring is correct
Thermopile Check
(
For standing pilot fireplaces
)
1. With the burner "ON" the Thermopile Millivolts must be greater than 200
-Action: Replace Thermopile if MV is less than 200
Remote Trouble Shooting Guide
Models: RC-BATT-HNG & RC-BATT-HTL
