- 4 –
6.3.
Adjusting the filtering
In the menu, select the “
F
” sign and do a
long tap
.
The filtering (sampling period) can be adjusted to make the response quicker or slower
during a gear change. It can be adjusted in 10 steps (from 0 to 9).
The factory default value is 4. Before changing this parameter, be sure to run the
Learning procedure first.
-
If the shift speed is quick (e.g. a quick shifter is used) and the indicated gears are
always correct then DECREASE the value for faster response.
-
If you notice that sometimes wrong gear is indicated momentarily during a
gearshift or under hard acceleration, INCREASE the value for slower response.
Note:
if wrong gear is displayed even with the filtering set to 9, there’s a problem with
the speed or RPM signals or the clutch is slipping.
6.4.
Adjusting the sensitivity of the light sensor
In the menu, select the “
b
” sign and do a
long tap
.
The ambient light sensor sensitivity can be adjusted in 10 steps (from 0 to 9).
The factory default value is 4. DECREASE the value if you’d prefer less brightness.
INCREASE the value if more brightness is desired.
Note:
If you set the value to 9, the brightness will be always at maximum, regardless of
the ambient light intensity.
6.5.
High Speed Warning function
If you wish, you may program the device to warn you when your speed exceeds a set
limit. The actual gear position will be flashing slowly with full brightness above the set
speed.
To ACTIVATE the HSW function:
-
Start the engine and let it idle.
-
In the menu, select the “
H
” sign and do a
long tap
.
The display shows a spinning wheel animation.
-
Start riding. The spinning wheel animation will speed up, indicating that it is
learning the highest speed value.
-
In top gear, slowly increase your speed to the desired target speed and keep it
steady for about 3 seconds.
-
Slow down carefully and stop (keep the engine running at idle).
“
U
” (update) is shown and the target speed is programmed.
To DEACTIVATE the HSW function:
-
In the menu, select the “
H
” sign and do a
long tap
.
The display shows a spinning wheel animation.
-
Do a
long tap
.
The target speed is cleared and the function is deactivated.
Notes:
-
Accessing the HSW function is possible only if the Learning was completed earlier.
-
Running the Learning procedure again will clear the HSW if it was active.
-
If the HSW function is activate and you run the activation procedure again, the
target speed value will be updated to the new one.
6.6.
Engine Speed Warning (Shift Light) function
If you wish, you may program the device to warn you when the engine RPM exceeds a
set limit. The actual gear position will be flashing rapidly with full brightness above the
set RPM.
