EDID Setup for the 4K30 HDMI input card
Demo video:
* To copy/learn EDID from the display
Step 1: Have an HDMI cable from the display directly connected to this HDMI input port
Step 2: Press the EDID key and hold for 3 seconds, the indicator will flashing
Step 3: Press the EDID key again until the indicator turns into solid light, EDID learning finished
*Factory default EDID mode will no need to plug the display, can press and hold the EDID key to
the flashing indicator status.
EDID Setup for the 4K30 HDBaseT input card
Demo video:
Step 1:
No need to turn off the matrix, plug out the HDBaseT input card from the Matrix Switcher
chassis, have the 4-DIP switch(DIP1, DIP2, DIP3, DIP4) set up to position (0,1,1,1). Have an HDMI
cable connected to the display from HDMI port on the HDBaseT input card, the HDBaseT port can
keep connected to the transmitter.
Insert the HDBaseT input card back to the matrix switcher, wait for about 15 seconds
Step 2:
Plug out the HDBaseT input card and have the 4-pin DIP switch(DIP1, DIP2, DIP3, DIP4) set
