Operating Instructions
Multipoint to multipoint network configuration:
1. Connect one HDMI Cable between the HDMI output port of source device and the HDMI input port of
Transmitter unit.
2. Connect one HDMI Cable between the HDMI input port of display and the HDMI output port of Receiver unit.
3. Connect one CAT5e or better cable between the RJ45 of each Transmitter unit and RJ45 port of Gigabit
Ethernet switch hub.
4. Connect one CAT5e or better cable between each RJ45 port of Gigabit Ethernet switch hub to RJ45 port of
Receiver unit. User can select source channel by setting up dip switch on each transmitter unit. And select
display devices for Receiver units via one remote control.
5. Use DIP switch to select sources .
How to use DIP switch:
1).Use 4-bit DIP switch to select 16 group ID (such as 0001, 0010, 0101 etc.)
2).Change group ID easily to select the sources.
3).For example, when the connection is :
Source( DVD1) - SX-EP22-TX (TX1) - Gigabit Switch - SX-EP22-RX(RX1)- TV1
Source (DVD2) - SX-EP22-TX (TX2) - Gigabit Switch - SX-EP22-RX(RX2)- TV2
Source (DVD3) - SX-EP22-TX (TX3) - Gigabit Switch - SX-EP22-RX(RX3)- TV3
The group ID of transmitters is :
TX1 (0001)
TX2 (0101)
TX3 (0100)
If you need display Source2 on TV1, then just set Group ID of RX1 same as TX2: 0101 (refer to Diagram).
7
