RS2 Wireless Switching Guide
HDC Inc.
www.poplocks.com
2
+
-
1.5 inches
38.1 mm
2 1/3 inches
59.182 mm
.5 inches
12.7 mm
To replace the Flex Switch, the battery cover must be removed.
Using only a fingernail or pen tip, depress the tab on the bottom
of the flex switch. Cover will hinge at the top revealing the inside
components. Replacement batteries are 12v part # GP23A,
CN23A, El12 and Vr22 or similar class battery.
Replacement battery must be installed as shown in Fig B. Its
orientation is specific to +- polarities clearly marked.
Replace cover and test.
1.) Use only plastic approved paints
2.) Clean surface to be painted as per paint MFG recommends
3.) Allow to dry sufficently before replacement and use.
Front and Cover
Side
Front with no cover
Flex Switch (RS 2)
+
-
Depress to open
Fig. B
Fig. A
The battery mates to the contacts and cradles
inside the bezel. Battery held in place only by
cover and contacts.
Flex Switch Specs
TM
TM
