XTND 4K (40m) Extender Manual
6
SETTING UP IR CONTROL
This will enable backwards IR control (the most common form of IR control) where IR signals from a remote in
your distant location is sent back to the extender and sent to your source device to make it appear as though it
is in the same room as you.
SOURCE CONTROL VIA IR (BACKWARDS IR)
1. Plug IR Transmitter TX into the 3.5mm jack port labelled IR TX on the XTND 4K (40m) Transmitter
2. Place IR Transmitter TX bud (small circular part) in front of the IR eye of the source (where you would nor-
mally point the remote to control the HDMI source device).
3. Plug IR Receiver RX into the 3.5mm jack port labelled IR RX on the XTND 4K (40m) Receiver.
4. Place IR Receiver at or near the display (position it close to where you would usually point your remote to
turn your TV on or off).
DISPLAY CONTROL VIA IR (FORWARDS IR)
1. Plug IR Transmitter TX into the 3.5mm jack port labelled IR TX on the XTND 4K (40m) Receiver.
2. Place IR Transmitter TX in front of the IR eye of the display (position it where you would usually point your
remote to turn on or off your TV).
3. Plug IR Receiver RX into the 3.5mm jack port labelled IR RX on the XTND 4K (40m) Transmitter
4. Place IR Receiver in a visible uncovered position where it is able to receive remote signals.
