HCIFitness PhysioStep LXT, Руководство пользователя

Страница: 17 / 18

17
1.3 Trouble Shooting Guide for the PhysioStep LXT
Symptom Possible Cause Solution
The LCD Screen does not
display anything when in use
The Adaptor is not plugged in?
Check that the Adaptor is correctly
connected to the Main Power
Socket and is correctly connected
to the Computer.
The Computer is faulty.
Replace the Computer by
contacting your dealer.
The Speed Display shows only
zero’s when in use
The Computer isn’t receiving a
signal from the Speed Sensor? (1)Check that the Sensor Magnet
is correctly fitted and passes in
front of the Sensor.
(2)Check the gap between Speed
Sensor and the Magnet is correct
5mm or less.
(3)Check that all the Computer
Plugs and Sockets are FIRMLY
and correctly connected.
(4)Check that the Computer Wires
are not damaged.
The Sensor is faulty. If all these Checks fail, then
replace the Sensor.
The Computer is faulty. Replace the Computer by
contacting your dealer.
The LCD Screen Partially
Displays
The connection between the
Circuit Board and the LCD Screen
Membrane is loose, gently press
down on the LCD Screen, If the
LCD Screen Partial Display
disappears then it is a connection
problem.
The connection between the
Circuit Board and the LCD Screen
Membrane is Misaligned. If this is
the problem you might be able to
see that the LCD Screen is on a
slight angle and NOT inline or
parallel with the Computer Case.
No Pulse Signal or incorrect
Chest Belt Signal
The Computer is NOT receiving a
pulse Signal. Check that you are wearing the
chest belt correctly.
The Computer is receiving a faint
of Intermittent Pulse Signal. (1) two grooved surfaces inside of
the strap must remain wet to
transmit accurately the electrical
impulses
of the heart back to the receiver.
(2)
Moisten the electrodes is very
important and be sure to fasten
the strap correctly below your
pectoral muscle.
(3)Clean the Pulse Sensors to
ensure a good contact between
your body and the Pulse Sensors.