HCI RM22A, Руководство по эксплуатации

Страница: 13 / 40

---------------------------------------------------------------------------RM22A/RM22D OPERATIONS MANUAL
HealthCare Information, LLC 13
SETUP AND OPERATION
Installing the IR Remote Control Batteries
1. Turn the IR Remote over. Press down on the arrow and slide the battery cover off the bottom.
2. Install the two included AAA batteries. The polarity is indicated on the bottom of the battery
compartment. Make sure the batteries are installed correctly.
3. Slide the battery cover back onto the remote and snap into place.
Function Codes
Setup features are accessed using function codes. You will need an IR remote control to enter function codes. To enter a function
code using an IR remote control, press the “FUNCTION” button followed by the“0”button then enter the function code. The
following codes are available.
CODE FUNCTION
9999 ACCESS TV OR DVD SETUP MENU
10086 TURN TV ON DURING OFF HOURS
11111 DISPLAY SOFTWARE VERSION
13218 DISPLAY DATE
14568 TEST MODE
15311 SET IR BAND TO BED ONE
15322 SET IR BAND TO BED TWO
15709 RESET
15428 SERVICE MODE
Note: If you change the IR band, your IR remote will no longer function until it is set to the same IR band as the TV. To
change the IR band of the remote, point the IR remote at the TV and press and hold the power button until the set turns
off.
Press the setup button on the IR remote after entering the “9999” code to access the TV / DVD setup menu.
Enter function code “15428” to keep the setup menu active until the TV is turned off. Once this code is entered you will not have
to enter the “9999” code until the set is turned off. Only one button analog or digital pillow speakers set for Zenith codes may be
used.
Pillow Speaker/Sip-puff Setup
Access the setup menu. Use the right arrow button to select the “LOCK” menu. Press the down arrow button to select “PILLOW
SPEAKER / SIP-PUFF”. Use the left and right arrow keys to select pillow speaker / SIP-PUFF you wish to use. See page 25 for
additional information.
Auto Scan
Access the setup menu. Use the right / left arrow button to select the “CHANNEL” menu. Press the right arrow button to enter
the "CHANNEL" submenu, press up / down arrow button to select “AUTO SCAN" item. Press the right arrow button to start the
auto scan process. The TV will scan all channels and store active channels in the program list.
Setting Date and Time
Certain features such as the “ALARM” require the proper date and time to function properly. To set the date and time:
1. Enter function code “9999” and press the “SETUP” button on the IR remote to enter the main setup menu.
2. Access "TIME" menu by using right / left arrow button, use up / down arrow button to select "CLOCK" item.
3. Use the left and right navigation buttons to select the number to be changed. Use the up and down arrow keys or the
number keys to set the correct date and time.
4. Press the “ENTER” button on the IR remote after all fields have been set.