HCI BM15AP2, Быстрый старт, Страница: 5 / 5

Setup
1. Install the IR remote control batteries.
A Turn the IR Remote over. Press down on the arrow and slide the battery cover off the bottom.
B.
Install the two included AAA batteries. The polarity is indicated on the bottom of the battery compartment. Make sure the batteries are installed correctly.
C. Slide the battery cover back onto the remote and snap into place.
2. Enter Admin Mode
A. Turn set on using the POWER button on the IR or touching the lower right corner of the screen. It takes the set about a minute to boot after power is applied
to the set before you can turn it on. After that there is a 5 second delay after you turn the set on/off before you can turn it on/off again.
B. Press the HOME button on the IR remote.
C.
Using an IR remote, press the function button. CODE: 0000000 will appear in red on the upper right of the screen.
D. Enter code 1236363. You can use the IR remote or virtual key pad on the screen. Apps drawer button will appear at the bottom middle of the screen.
3. Scan for channels (must be in admin mode)
A. Press the SETUP button on the IR remote.
B. Touch Television, CHANNEL, Auto Program, Search Cable Channels, OK The set will now scan for viewable channels and create a channel line up.
Note: If the set is connected to an antenna, select Search Air Channels instead of Search Cable Channels.
C. Wait for scan to complete. This may take up to 20 minutes depending on the number of digital channels present.
The set is now ready for basic use. For advanced setup download the full Operations Manual from www.hcic.com . Direct link to the manual is
https://www.hcic.com/wp-content/uploads/2015/07/BedMateAP-Operations-Manual-Rev-1-1.pdf
4.
Cloning (must be in Admin Mode)
A. Generate clone file.
a.
Insert a USB flash drive into any USB port on the set. The side port is usually easiest to get to.
b.
Enter Admin Mode and press the SETUP button.
c.
Scroll down the left column and touch Clone & Reset followed by Generate Clone File. Wait for the process to complete. This may take several minutes.
B. Restore clone file.
a.
Move the USB flash drive to a set that you wish to copy the setup to.
b.
Enter Admin Mode and press the SETUP button.
c.
Scroll down the left column and touch Clone & Reset followed by Restore Clone File. Wait for the process to complete. This may take several minutes.
d.
Repeat B. for all sets.
Note: The following will not clone, IP setup, flash drive content, user installed apps, app data and some widget setup information.