HBM QuantumX CX22, Руководство по эксплуатации

Страница: 37 / 88

37
QuantumX Data Recorder CX22‐W
A3169-1.0 en/de HBM
Set the outputs via the limit value and event monitoring: Enter 0 HIGH (LED4)
under Bit/Condition if output 4 should become active when the event occurs
(LED 4 lights up green). Outputs 5 and 6 are activated via Bit 1 (LED 5) and
Bit 2 (LED 6).
Tip
At the start of a DAQ job, outputs are reset to LOW if you activate the setting
Reset all CX22 digital outputs on DAQ start in the Options for the CX22‐W
(group System ) in catman
®
AP.
10.3.5 LED for operating state of CF card
The LED on the rear of the module flashes yellow when data are written to or
read from the CF card.
10.4 Microphone input, loudspeaker output
The microphone input allows you to connect a standard PC microphone
(powered by the CX22‐W).
Microphone power supply
Microphone signal
Ground
Fig. 10.1: Microphone input pin assignment
You can either connect an active PC loudspeaker/headphones to the loud­
speaker output or you can feed the signal as Line‐Out to a (HiFi) amplifier.
Left
Right
Ground
Fig. 10.2: Loudspeaker output pin assignment