HBM FS63 series, Руководство по установке

Страница: 13 / 20

Sensor Installation
FS63
A4262-3.2 HBM: public
13
Fig. 2.7
Proceed with the second sets of shots as shown in
Fig. 2.7 .
To ensure a complete strain isolation form the sensor,
only one half of the sensor should be welded.
2.5 Protecting the Sensor
For the weldable temperature sensor it is advisable to
further protect the sensor. The following instructions are
only suggestions of procedure.
2.5.1 Moisture Protection
To protect the sensor from direct moisture contact, HBM
FiberSensing uses a synthetic air tight rubber
(Polyisobutylene rubber).