HBK CA80, Инструкция по эксплуатации

Страница: 10 / 36

CA80
APPLYING THE CA80 ADHESIVE
8
Unnecessary distribution of adhesive on the measurement object can be prevented by
using a "mask".
u
Apply adhesive tape around the installation area at a distance of approx. 5 to 10mm
(
see Fig. 5.4 ).
Mask, adhesive tape around the
measuring point with approx. 5 to 10 mm
distance
Adhesive tape for folding the SG back
Fig. 5.4 Preparing the SG installation point
6 APPLYING THE CA80 ADHESIVE
u
Unscrew the cap.
u
Carefully cut off the tip of the dropper. After use, close it again by replacing the cap.
u
Firmly push the plastic tip onto the drop nozzle. The dosing tip dispenses very fine
drops of CA80 and also allows adhesive to be applied to places that are difficult to
access.
If the adhesive is not used for a long time, it will harden and seal the tip. Clean the dosing
tip or cut it down so that it can be used again.
Important
Please note the following points after using the adhesive:
u
Remove the dosing tip immediately from the drop nozzle.
u
Remove adhesive residues from the drop nozzle with a lint-free cloth. This will prevent
the cap becoming bonded to the drop nozzle.
u
Put the cap back on the bottle immediately to close it. This will stop any moisture get­
ting into the bottle and rendering the adhesive unusable.
u
Tap the end of the dosing tip against an absorbent base to remove any residual
adhesive.
u
Eject any residual adhesive from the capillary tube with a disposable syringe or by
gently tapping it against an edge.
To reduce the risk of the drop nozzle drying out, you can additionally seal it with a pin
after use. Then put the cap back on for secure storage.