HB-THERM M8098, Руководство по сборке, Страница: 3 / 6

Assembly Instructions M8098-EN
M8098-EN 2018-03
3/6
6. Proceed as follows in order to remove the covers:
Fig. 3: Flow-5 with ball valve
Fig. 4: Flow-5 view from below

If present disassemble shut-off valve OUT 1 and 4
(Label 3

Fig. 3).

Disassemble screws (Label 4

Fig. 3), remove cover and
insulation.

Disassemble screws (Label 5

Fig. 3), remove cover and
insulation.
Only in the event of a replacement temperature sensor return
line (BT 2 x):

Disassemble screws (Label 6

Fig. 4) and remove cover.
7. Replace temperature sensor main line (BT 1) or return line
(BT 2.x) while proceeding as follows:
Fig. 5: Flow-5 side view from the right

Disconnect temperature sensor (BT 1, BT 2.x) at the flow rate
measuring board DFM-51 (A 9.x).

Disassemble temperature sensor (BT 1, BT 2.x) (

Fig. 5).

Transfer label of temperature sensor to new temperature
sensor (BT 1, BT 2.x) and install(

Fig. 5).

Connect temperature sensor (BT 1, BT 2.x) at the flow rate
measuring board DFM-51 (A 9.x).
BT 1
BT 2.x
5
3
4
BT 1
BT 2.x