HazeBase THE FAB, Инструкция по эксплуатации

Страница: 9 / 28

THE FAB
In the center of the screen is the value area. The current value to be edited is always
displayed here. A short tap within the circle starts THE FAB. This activates the heating,
the pump, the fans and the air baffles are switched active.
A further tap in the value range ends the Haze process again. This is always followed
by an approx. 40 sec. cleaning process of the evaporator. Afterwards, everything is
switched off again.
Furthermore, there is a display of the fluid level around this value range. If fluid is
nebulized, the orange part of the display decreases steadily.
There are two icons at the top center of the screen. The left symbol indicates a
connection via Ethernet, the right symbol shows whether THE FAB is connected to the
mains supply or is currently being supplied via the internal battery. In the case of
battery operation, the battery charge status can be read here.
At the top right and at the bottom are the keys for plus and minus. In the middle
between them the current DMX address can be read.
At the bottom center is the button for advanced settings.
6.2 Operation in stand-alone mode
The simplest case of control is the stand-alone mode. For this purpose, the pump
value, the fan speed and the angle of attack of the air baffles are set and the haze
process is started.
When the Haze process is
active, the bars next to the
respective values are displayed
in green.
The individual values can be
changed
by tapping the
desired value (in the picture
the pump value) and then
changing it with the plus and
minus keys.
8