background image

 

 

 

USE ONLY HAYWARD GENUINE REPLACEMENT PARTS 

Page 4 of 15 

VL Series Pump 

ISVL1285  Rev B 

 

 

WARNING

 – Pool and spa components (seals, gaskets, etc.) have a finite life.  All components should be 

inspected frequently and replaced at least every ten years, or if found to be damaged, broken, cracked, missing, or 

not securely attached. 

 

WARNING

 – Risk of Electric Shock.  All electrical wiring MUST be in conformance with applicable local 

codes, regulations, and the National Electric Code (NEC).  Hazardous voltage can shock, burn, and cause death or 

serious property damage.  To reduce the risk of electric shock, do NOT use an extension cord to connect unit to 

electric supply.  Provide a properly located electrical receptacle.    Before working on pump or motor, turn off power 

supply to the pump. 

 

WARNING

 – 

(For all cord- and plug-connected units) WARNING - To reduce the risk of 

electric shock, replace damaged cord immediately.

 

 

WARNING

 – Risk of Electric Shock.  In accordance with the National Electric Code (NEC), connect only to a 

branch circuit protected by a ground-fault circuit-interrupter (GFCI).  Contact a qualified electrician if you cannot 

verify that the circuit is protected by a GFCI.  The unit must be connected only to a supply circuit that is protected by 

a ground-fault circuit-interrupter (GFCI).  Such a GFCI should be provided by the installer and should be tested on a 

routine basis.  To test the GFCI, push the test circuit button.  The GFCI should interrupt power.  Push the reset button.  

Power should be restored.  If the GFCI fails to operate in this manner, the GFCI is defective.  If the GFCI interrupts 

power to the pump without the test button being pushed, a ground current is flowing, indicating the possibility of an 

electric shock.  Do not use this pump.  Disconnect the pump and have the problem corrected by a qualified service 

representative before using. 

 

WARNING

 – Suction Entrapment Hazard.  Suction in suction outlets and/or suction outlet covers, which 

are damaged, broken, cracked, missing, or unsecured cause severe injury and/or death due to the following 

entrapment hazards (symbols complements of APSP): 
Hair Entrapment - Hair can become entangled in suction outlet cover. 
Limb Entrapment - A limb inserted into an opening of a suction outlet sump or suction outlet cover that is damaged, 

broken, cracked, missing, or not securely attached can result in a mechanical bind or swelling of the limb. 
Body Suction Entrapment - A differential pressure applied to a large portion of the body or limbs can result in an 

entrapment.  
Evisceration/ Disembowelment - A negative pressure applied directly to the intestines through an unprotected 

suction outlet sump or suction outlet cover which is damaged, broken, cracked, missing, or unsecured can result in 

evisceration/disembowelment. 
Mechanical Entrapment - There is potential for jewelry, swimsuits, hair decorations, fingers, toes, or knuckles to be 

caught in an opening of a suction outlet cover resulting in mechanical entrapment. 

Содержание SP8100
















Отзывы: