XX
TOWBAR
INSTALLATION INSTRUCTIONS
PART NUMBER
03276RW
FORD RANGER PX3 CL4 CN UTE
49-75 Pacific Drive Keysborough, VIC 3173
Phone: 1800 812 017
Email: [email protected]
Rev:
C
Page
5
Issue Date:
04-03-2020
2.2
For Vehicles with Plastic Rear Bumper
Remove the bolts from either side of the plastic rear
bumper, and remove the plastic bumper from the
vehicle.
NOTE: Place the bumper step assembly on a safe
place to avoid damage.
Release the 2 x lock nuts on each side of the bumper
and slide the step mount bracket outwards to have a
gap of 1200mm. The lock nuts are located on the
underside of the bumper.
2.3
For Vehicles with Factory Fitted Towbar
Remove the 2x M12x 40 Step bolts from either side of
the Bumper step assembly as shown and make sure to
retain the 2 sets of M12 step bolts.
Remove Towbar.
3.
Move Wire Loom located on Diff Housing
Remove wiring loom mounted on the diff housing.
Drill an 8mm hole through the connector bracket from
bottom to top surface which is welded on the diff
housing as shown. Apply anti-rust or paint to newly
drilled hole to prevent corrosion.
Mount the wiring loom on the newly drilled top hole
of the connector bracket.
Drill
Direction
