To turn OFF the Beeper Collar remotely:
•
Flip the Toggle Switch to the down position.
•
Press the Upper Button** on the Master Transmitter.
*The Power Switch on the Beeper Collar must be in the Standby position for the remote on/off to work. To save battery life,
the Power Switch should be in the off position. **Upper Button: Dog #1, Lower Button: Dog #2, Side Button: Dog #3
•
Add-On Collar 2
– repeat steps A to G, but press Lower Button (instead of Upper button) in step D.
•
Add-On Collar 3
– repeat steps A to G, but press Side Button (instead of Upper button) in step D.
Pairing a Dog & Gun button
It is also possible to pair a maximum of 10 Dog & Gun button transmitters to just one Master Transmitter.
This may be a requirement for the following applications:
•
Multiple dogs each having a different stimulation level
•
Multiple levels and multiple buttons
•
A set of buttons for different guns (20g, 12g, 10g)
Pair your First Button
Test your unit by pressing the button and watching the collar receiver for a command flash. Note the level
has been set by your stimulation level selection. See page 5 for changing intensity in Dog & Gun mode.
The procedure can be repeated for a maximum of 10 Dog Gun buttons.
*In
Dog & Gun Program Mode
, if no signal is received from the DG in 10 seconds, the Master Transmitter will automatically
switch back to
Dog & Gun Run Mode
.
25
