INSTALLATION PROCEDURE FOR LIGHT POLE:
1.
Prepare footing as required by local codes, see Fig. 1, Fig. 2 and Fig. 3 for
recommendations.
2.
Set wooden anchor template in position over conduit. ‘F’ on the template indicates
the Front of the unit.
3.
Mark four anchor hole locations and remove the template.
4.
Drill holes according to anchor size and depth. Clear holes of debris.
5.
Set unit in place, ensuring that base sits flat on concrete, and install anchors
according to anchor manufacturer’s recommendations.
6.
Using 3/16” hex key, adjust leveling glides until unit is plumb.
Fig. 6 – Remove access panel
PROCEDURE FOR INSTALLING CABINET COVERS:
1.
Set retainer bar in the casting pocket.
2.
Install cabinet covers as shown, ensuring bottom tab of cover rests in the groove in
base casting. Repeat for remaining three covers.
3.
Install cabinet dome cover by threading into the retainer bar until tight.
PROCEDURE FOR WIRING HAWTHORNE:
The Hawthorne pathway light is assembled at the factory. The light cartridge is
mounted into the head of the pole and will not need to be removed during
installation. The LED cartridge is wired to the driver (located in the cabinet) at the
factory.
The following schematic is to be used to connect the unit to line voltage. It is the
responsibility of the installer to make sure that all connections are made in accordance
with the NEC and local building codes. Connection hardware not included.
Fig. 7 – Access panel removed
Landscape Forms is not responsible for site preparation and footings. Footing
recommendations are included in these instructions.
Installation Guide
Hawthorne
Pathway Light
www.landscapeforms.com Ph: 800.521.2546
Page 2 of 2
Date: April 14, 2015
Fig. 8 – Hawthorne Type 4 wiring schematic
