24
10.
If any problem occurs, pull the rope of the quick release mechanism. The metal locking bar will be
released automatically because of the weight of the machine, and the machine will drop away from
you.
11.
If the engine is hot,
on/off swtich
level can be adjusted to the ‘I’ position when restarting the
brush
cutter.
NOTE:
If the engine does not start up after several attempts, read the section ‘
Troubleshooting
’.
NOTE:
Friction around the eyelet will be created and the chord will become frayed if pulled at an
angle. This may result in premature breakage of the chord. The recoil starter handle should be
allowed to slowly return back to its starting position and never be allowed to 'snap back'.
NOTE:
Do not start the motor in long grass.
ATTENTION:
When the engine has been switched off, the cutter continues running for several
seconds; therefore, do not touch the cutter head until it has come to a complete standstill.
Working instructions
Extending the cutting line
CAUTION!
Do not use any kind of metal wire or metal wire encased in plastic in the line
spool. This may cause serious injuries to the user. To extend the cutting line, run the engine
at full speed and tap the line spool on the ground.
This will automatically extend the line.
The blade on the safety guard will cut the line to the appropriate length.
