Note:
Tape armour must be
re-trimmed at 90° to the
vertical axis of the cable
after it has been spread,
to ensure that the full
face is correctly
presented.
I
Braid 'X',
Flat Steel Wire 'Y',
Steel Tape 'Z'
Ring Position
SWA
Position
General identification ring orientation for:
Reversible Armour Clamping Ring (RAC)
Gland Type: PSG 553/RAC
Exdb IIC Gb, Exeb II Gb, Extb IIIC Db
Baseefa06ATEX0056X II 2 GD IP66
IECEx BAS06.0013X
IEx 14.0272X
EAC ТC RU C-GB.ГБ05.B.00750
CNEx07.0897X
Certification Details
Assembly Instructions for cable gland:
PSG 553/RAC
Operating temperature range -60°C +80°C
Note:
Cable acceptance sizes are marked on the
diaphragm seal, clamping ring and backnut.
www.ehawke.com
UK Office
Oxford Street West,
Ashton-Under-Lyne,
Lancashire. OL7 0NA. UK
Sales: +44 (0) 161 830 6698
Technical: +44 (0) 161 830 6697
Fax: +44 (0) 161 830 6648
E-mail: [email protected]
Connection Solutions
AI 312 - Issue R / Page 1 of 2
A member of the Hubbell Group of Companies
AI 312 / Issue R - 06/17
IMPORTANT
: The arrowhead indicating the
correct armour thickness or type should point
towards the equipment
Hawke International is a division of Hubbell Ltd.
Registered No. 669157 in England. Registered Office:
Cannon Place, 78 Cannon Street, London EC4N 6AF.
1. Backnut
2. Middle Nut
3. Reversible Armour Clamping Ring (RAC)
4. Armour Spigot
5. Seal
6. Entry (with captive deluge seal), if required
Cable Preparation
A
Strip Cable to suit equipment as shown above and
expose the armour/braid '
I
' removing all cable fillers.
'
I
' = 20mm for cable gland sizes Os to C
'
I
' = 25mm for cable gland sizes C2 to F
'
II
' = to suit equipment.
If required, fit shroud.
C
Remove the inner seal
from the entry
. Place
the entry
over the armour spigot
. Move the
sub-assembly
and
up to meet the entry
.
B
Push the cable through the armour spigot
. Spread
armour/braid over the armour spigot
until the end
of the armour/braid is up against the shoulder of the
armour cone. Position the armour clamping ring
.
Gland Preparation
Shroud Option
II
I
Armour/braid
5
6
4
3
2
1
3
2
1
3
2
1
4
6
5
3
2
1
4
MACDEM
P. O. Box 16, Moscow, 119571, Russia
Email: [email protected]
Tel / Fax: +7 595 778 1264
Website: www.macdem.ru
For any enquiries within EAC countries,
please contact:
Product supplied may differ
slightly from that shown.
Images are for illustration
puproses only.
