Hawk HA-260RS, Руководство по установке

Страница: 2 / 8

INSTALLATION POINT TO REMEMBER
This product represents many years of research and development. It is very sophisticated and should be installed by experienced security
installers only. Please do not attempt installation of this product without reading this guide. The system has been designed to provide the
ultimate in security, coupled with limitless convenience and expansion options.
Do not disconnect the battery if the vehicle has an anti-theft coded radio. If equipped with an air bag, avoid disconnecting the battery if possible.
IMPORTANT!
Many airbag systems will display a diagnostic code through their warning light after they lose power.
Disconnecting the battery requires this code to be erased, a procedure that can require a trip to the dealer.
DECIDING ON COMPONENT LOCATIONS
LOCATIONS FOR THE SIREN
Some things to remember about mounting the siren:
• Keep it away from heat sources, such as radiators, exhaust manifolds, turbochargers and heat shields.
• Mount it where a thief cannot easily disconnect it, whether the hood is open or shut. Both the siren and its wires should be difficult
to find. This usually involves disguising the wire to look like a factory harness.
• When possible, place the siren on the same side of the vehicle as the control module, where its wires will reach the control moduleʼs
wires without extending them. Always run the wires through the centre of a grommet, never through bare metal!
• Point the siren down so water does not collect in it.
LOCATIONS FOR THE CONTROL BOX
Some things to remember about where to mount the control module:
• Never put the control module in the engine compartment!
• The first step in hot wiring a vehicle is removing the driverʼs side under-dash panel to access the starter and ignition wires. If the
control module is placed just behind the driverʼs side dash it can easily be disconnected.
• When mounting the control module, try to find a secure location that will not require you to extend the harness wires. Keep it away
from the heater core (or any other heat sources) and any obvious leaks.
• The higher the control module is in the vehicle, the better the transmitter range will be. If you put the control module under a seat or
inside a metal dashboard, range will suffer.
• Some good control module locations: above the glove box, inside the centre console, above the under dash fuse box, above the
radio etc.
LOCATIONS FOR THE STATUS LED
Things to remember when positioning the Status LED:
• It should be visible from both sides and the rear of the vehicle, if possible.
• It needs at least ½” clearance to the rear.
• It is easiest to use a small removable panel, such as a switch blank or a dash bezel. Remove it before drilling your ½” hole.
LOCATIONS FOR THE HAWKGUARD SHOCK SENSOR
Some things to remember about where to mount the shock sensor:
• Never put the shock sensor in the engine compartment!
• Find a spot close to the control module so that the wires to not need to be extended. Keep it away from the heater core (or any other
heat sources) and any obvious leaks.
How the shock sensor is mounted is the most important factor in its performance. We recommend 2 methods:
• using double-sided tape or hook-and-loop fastener to mount to a trim panel or an air duct, or
• Wire-tying to a wire harness.
LOCATIONS FOR THE HAWKGUARD ULTRA SONIC SENSORS
Ultrasonic cells should be placed on the left and right side as high as possible so to obtain the best performance.
Inappropriate adjustment for the Ultrasonic sensor may let to a false alarm. To prevent the false alarm, make sure the sensibility of ultrasonic
sensor is in an appropriate degree. An over adjustment is usually the main reason to cause false alarm.
1