www.havis.com • 1-800-524-9900
DS-GTC-201
DS-GTC-201-3
DS-GTC-202
DS-GTC-202-3
DS-GTC-203
DS-GTC-203-3
Before Beginning
(Original Instructions)
2
11
• NEVER STOW OR MOUNT THE DOCKING STATION DIRECTLY IN A VEHICLE
AIRBAG DEPLOYMENT ZONE.
• DO NOT USE COMPUTER WHILE DRIVING.
Havis is pleased to provide this Owner’s Manual to aid in the proper
installation and use of the DS-GTC-200 Series Docking Station for
the Getac F110 Rugged Tablet.
This Owner’s Manual applies to the following Part Numbers:
• FOR DOCKING STATION MODELS EQUIPPED WITH A BUNDLED POWER SUPPLY
(DS-GTC-202, DS-GTC-202-3)
REFER TO THE SUPPLIED LIND POWER SUPPLY REFERENCE GUIDE.
• WHEN TABLET IS DOCKED, THE BATTERY WILL ONLY CHARGE BETWEEN
0°C to 50°C (32°F to 122°F).
PLEASE REFER TO GETAC F110 OWNER’S MANUAL FOR MORE INFORMATION.
Optional Accessories
DS-DA-311 - Remote USB Extension Cable
(For further Installation Instructions, refer to the Instructions included with DS-DA-311)
1)
Determine if USB will exit the left or right side of Docking Station.
2)
Remove the Screws from USB Cable.
3)
Align the female end of the USB Cable with mounting surface hole pattern.
Insert Screws and Lock Washers and tighten Screws.
CAUTION: DO NOT OVERTIGHTEN SCREWS
4)
Plug male end of USB Cable into USB Port.
5)
Strain Relief cable as needed.
6)
If the connected peripheral has a cable requiring strain relief, use
Int. Zip Tie (Hardware Kit Item #1) by snapping into hole just below port.
7)
Continue on with Installation on Page 6.
Screws
Lock Washers
USB 2.0 Panel Mount Extension Cable
Mounting Surface
USB Port
Male End
Female End/
Panel Mount
• READ ALL INSTRUCTIONS THOROUGHLY BEFORE BEGINNING INSTALLATION.
• DO NOT DOCK OR UNDOCK YOUR COMPUTER UNLESS IT IS POWERED OFF. DOCKING OR
UNDOCKING WITH YOUR COMPUTER IN ON, STANDBY, HIBERNATION, OR SLEEP MODES
CAN CAUSE PERMANENT DAMAGE.
• FOR THE DS-GTC-201, DS-GTC-201-3, DS-GTC-202 & DS-GTC-202-3 DOCKING STATIONS:
DO NOT CONNECT DIRECTLY TO VEHICLE VOLTAGE SOURCE: This product requires
a certified, automotive grade, Getac approved 95W power source rated for a
continuous, regulated 19VDC output
(Havis Part Number LPS-116 or equivalent)
.
Failure to comply with this requirement will cause product damage that is NOT
repairable and is NOT covered under warranty.
• FOR THE DS-GTC-203 & DS-GTC-203-3 DOCKING STATION:
DO NOT CONNECT DIRECTLY TO VEHICLE VOLTAGE SOURCE: The Getac F110 tablet
requires a certified, Getac approved power source rated for a continuous, regulated
19VDC output. Getac recommends using the power adapter included with the tablet;
failure to comply with this requirement will cause product damage that is NOT repairable
and is NOT covered under warranty.
