KK-K9-F12-K-INST-6-06
Page 2
2. Remove rear OEM door panels:
•
Remove speaker, door handle, and lock
•
Remove switch assembly from plastic housing (leave
plug on switch)
Note: if doors have electric door switches, they must be reattached to
original plug assembly. Switch assembly must then be wired-tied
down so it does not interfere with window or door latch operations
3. Install mounting legs:
•
Using ¼-20 x ¾” carriage bolts attach mounting legs
to floor of vehicle using 1/4” x 1 ½” hex head lag screws.
Note: keep nuts loose at this time. And set legs at 6 1/2” high.
4. Slide in K-9 main housing:
•
Slide in main housing.
•
Housing should be 48 ½” from rear plastic sill to
rear mounting flange.
•
Mount legs to housing loosely, using ¼-20 x ¾”
carriage bolts.
•
Mount rear support to bottom of rear housing using
(6) ¼-20 x ¾” hex head cap screw.
5. Install tunnels and fillers:
•
Loosely attach side tunnels to main housing using
¼-20 x ¾” carriage bolts and ¼-20 x ½” carriage
bolts.
•
Place sill plate and cover step in tunnels and
mount with #12 x ¾” stainless sheet metal screws.
6. Housing final step:
•
Center housing so cover steps are even on both
sides.
•
Mount rear housing to vehicle with ¼” x 1 ½” hex
head lag screw.
•
Tighten all loose bolts on tunnels and legs.
Note: If 32” inch long K-9 kit is being installed, a 10”
rear floor extension must be used. (provided with 32”
kits)
Front Driver Side Leg