C-3190-F-INST-10-06
TECHNICAL SERVICE BULLETIN
Subject
:
Trunk Tray Installation (Part # C-3190-F: Full Width Tray )
Vehicle
:
2005 and newer Ford Crown Victoria Police Interceptor
Problem
:
The Fuel Pump wire harness on 2005 mid model year Crown Victoria’s and newer is now
routed on the rear (trunk) side of seat strainer (metal framework behind rear seat). The location of this
harness now interferes with the mounting bracket for the Havis-Shields full width trunk tray. Harness is
subject to being pinched by bracket.
Solution
:
The mount plate that connects to the seat strainer must be spaced out so it will not
damage harness. In addition to the original hardware kit, four (4) # GSM30008 3/8-16 hex nuts and one
(1) foot # PRM97913 protective wire loom must be used. One (1) 3/8-16 hex nut spacer is used with
each of the four ¼” x 1” bolts (between the seat strainer and tray mount plate). The protective wire loom
must be wrapped around wire harness before mount plate is fastened.
Check
: Before and after all hardware is tightened, make sure wire harness is not pinched.
NOTE:
Havis-Shields Part #C-3190 (Drivers Side) Trunk Tray mounting should not be affected. The harness can
easily be moved out of the way.
Havis-Shields is committed to quality workmanship and Technical Support.
Please contact our team at 1.800.524.9900 with questions &/or comments.
