Haussmann 58485002, Руководство оператора

Страница: 20 / 28

INSTALL THE DRILL PRESS HEAD
Refer to Figure 4.
• Position and slide the head over the column.
• Carefully rotate the head on the column so it is aligned
with the base.
• Secure the drill press head with two lock set screws,
using the hex wrench.
Figure 4
INSTALL HANDLES
Refer to Figure 5.
• Locate the three thread holes on the hub of the head.
• Thread the handles into the holes of hub until tight.
Figure 5
INSTALL THE CHUCK
Refer to Figure 6.
Clean the spindle taper and the tapered hole in the chuck
before assembly. Remove factory protective coating with
alcohol or household oven cleaner.
• Rotate the chuck sleeve counterclockwise and open the
jaws as wide as possible.
• Place chuck on the taper of spindle and gently tape the
chuck into position with a rubber hammer or a hammer
with wood block. Never use metal hammer directly.
Figure 6
MOUNT DRILL PRESS
Refer to Figure 7
• The machine must be installed in a well-lighted area
with correct power supply.
• The machine can be installed on either a workbench or
a tool stand by using bolts, lock washers, and hex nuts.
• The machine must be bolted to a firm and level surface.
• There must be proper clearance to adjust the workpiece
before and after the operation is complete. There must
be sufficient room to safely operate the machine.
Figure 7
19
WARNING
HEAD
ASSEMBLY
ARBOR
SCRAP
WOOD
MALLET
CHUCK
Mounting Holes
FEED
HANDLE
HUB
HEAD
ASSEMBLY
SET SCREW