rev. 07.23.08 cjr
©2008 PROTEAM BY HAUSMANN
ASSEMBLY INSTRUCTIONS
Clear the area where you will be working and lay down a blanket. Remove all parts from the box and follow the
directions below.
1. Attach Corner Legs “A” with pre-drilled holes facing Leg
Plate “L” and fasten with Hex Head Bolt “N”, 5/16” Split
Washer “P” and 5/16” Flat Washer “O”. Use 1/2” socket
wrench to tighten the Hex Bolts. Attach the Center Legs
“D” with Carriage Bolts “I” and 1/4” Kep Nut “J”. Apply
soap or wax lubrication if needed. Use 7/16” socket
wrench to tighten the carriage bolts.
IMPORTANT: See Illustrations 2 and 3 for tightening
instructions and part placement.
2. Place the Short Stretchers “F” into the slots on the
Corner Legs “A” with the laminated edge facing the
table top. Secure with Flat Head Allen Head Cap Screw
“B” (2 per stretcher). Use Allen Wrench supplied by
Hausmann. (See Illustration 4).
3. Identify the Long Stretchers “C”. There are three long stretchers - two are pre-drilled with holes which line up
with the holes located on the inside of the two Center Legs “D”. Place the long stretchers into the slots of the
Short Stretchers “F” with the laminated edges facing the table top and secure at the ends using (6) Flat Head
Allen Head Cap Screws “B” Then secure the middle of the two outside long stretchers to the center legs using
(2) fl at head allen head cap screws. Use the Allen Wrench supplied by Hausmann. (See Illustration 5).
4. Turn the table right side up. Hook and loop velcro strips are factory attached to the bottom of the Long Shelf “E”.
Remove the loop strips of velcro and adhere them fi rmly to the TOP of the 2 outside Long Stretchers “C” as well
as the TOP of the 2 Short Stretchers “F” in corresponding locations to the hook velcro strips. (See Illustration 1).
5. From one end, place the Long Shelf “E” on top of the stretchers and secure with the corresponding velcro strips
placed during step 4.
NOTE: Placement of velcro strips are to be aligned with each other for secure assembly.
6. Double check to make sure all screws are tight and secure.
PREVENTATIVE MAINTENANCE
1. Inspect bolts and other mechanical fasteners at least every 3 months. Tighten bolts, screws or connectors if
loose.
CAUTION: Tighten until snug but do not overtighten.
2. Please inspect all parts for satisfactory condition. Call your dealer immediately if a problem exists. Discontinue
use of any product that is not in proper working order until situation is rectifi ed.
For assistance please call Hausmann Industries for service at (201) 767-0255. Press “5” for Customer Service.
We may request purchase details (date purchased, dealer) to better assist you.
A
Corner
Leg
Illustration 2
L
Leg
Plate
O
Flat Washer
P
Split Washer
N
Hex Bolt
IMPORTANT: You must
tighten Hex Bolt until Split
Washer is compressed
FLAT against Flat Washer.
DO NOT OVERTIGHTEN.
Factory installed threaded
insert
Pre-drilled
hole to face
inward
A
D
L
J
I
O
N
P
F
B
B
B
B
C
Illustration 5
Illustration 4
Illustration 3
