Hauppauge WinTV-USB, Инструкция по установке и справочник

Страница: 39 / 64

Using Audio with WinTV-Capture
To capture audio along with video, the WinTV USB must be connected to a
sound board capable of saving sound clips. To connect the USB to a sound
board do the following:
a) Make sure the audio output of the card is plugged into the LineInput of the
sound board.
b) Make sure the LineInput volume for recording is set correctly and not
muted. Open the Volume control panel, then click on Options / Properties . In
the panel Adjust volume for recording set for Recording . Make sure
LineInput is checked under Show the following volume controls and that the
volume for LineInput is not muted and is set at an appropriate level .
Capturing audio along with video puts a greater
strain on your PC than capturing video alone. If your
PC drops many frames while capturing audio and
video together, then capture the audio separately with the audio
capture utility from Windows. The audio can be merged with
video later on during the video edit stage.
Suggestions on capturing video
Captured image sizes can be either 160x120 or 320x240 pixels.
For the best trade off between image size and captured frames per second, use
a 320 x 240 image. With a 166MHz processor MMX (or better) and a reasonably
fast hard disk drive, you should be able to capture 30 frames per second using
the YUY2 OR RGB format.
WinTV-USB
Installation and Reference Manual
3-5