Page 4
For technical questions, please call 1-888-866-5797.
63772
Assembly Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the
beginning of this manual including all text under subheadings therein before
set up or use of this product.
Note:
For additional information regarding the parts listed in the following pages, refer to
Parts List and Diagram on page 10.
Note:
Top of Ramp is where tongues (angled
lips) are located.
Note:
Assemble Ramps on a safe and secured
area with plenty of room for assembled Ramps.
1. Place Connection Plate G (4) at the
bottom right side of Upper Ramp (2).
Bottom
Ramp (1)
Upper
Ramp (2)
Connecting
Plate G (4)
Connecting
Plate F (5)
Right
Side
Left
Side
Same Ramp
Upper
Ramp (2)
Bottom
Ramp (1)
Connecting
Plate I (7)
Connecting
Plate H (6)
2. Install two M10x20 Bolts (8), four
M10 Flat Washers (9) and two
M10 Lock Nuts (10) into two mount
holes attaching Connection Plate G
to Upper Ramp frame, bottom
right side. Refer to
Figure A.
Mount holes attaching to Ramp Frame
Lower swivel mount holes
4,7
5,6
Figure A: Mount Hole Callouts.
3. Place Connection Plate I (7) at the
bottom left side of Upper Ramp.
4. Install two M10x20 Bolts, four
M10 Flat Washers and two
M10 Lock Nuts into two mount
holes attaching Connection Plate I
to Upper Ramp frame, bottom
left side. Refer to
Figure A
.
5. Place Connection Plate F (5) at the
upper right side of Bottom Ramp (1).
6. Install two M10x20 Bolts, four
M10 Flat Washers and two
M10 Lock Nuts into two mount
holes attaching Connection Plate F
to Bottom Ramp frame, upper
right side. Refer to
Figure A
.
7. Place Connection Plate H (6) at the
upper left side of Bottom Ramp.
8. Install two M10X20 Bolts, four
M10 Flat Washers and two
M10 Lock Nuts into two mount
holes attaching Connection Plate
to Bottom Ramp frame, upper
left side. Refer to
Figure A
.
