Hatteland JH 10T08 MMC, Руководство пользователя

Страница: 18 / 60

18
INB100014-1 (Rev 27)
IND100133-36
Physical Connections - MMC based models
PCI Slots 1&2: (Not available on all models!)
Supports PCI (Short Length / Standard Profile) card in two available slots. These PCI cards are
normally installed from factory or returned to factory for upgrading if needed. Note that warranty
will be void if you install PCI cards yourselves. In order to mount PCI cards, the chassis of the unit
must be removed, thus making warranty void as the warranty sticker would have to be broken.
The PCI slots are not available on all MMC ETX models, due to space restrictions.
COM1,2,3,4 Serial Ports INPUT/OUTPUT:
Supports RS232 / RS422 / RS485 using D-SUB 9P Male connectors. Fasten the cable to the
connector using the provided screws on the cable housing itself. (Factory default is RS232 only)
Internal Serial Remote Control (SCOM):
This is only an internal serial port and are available in the operating system as “COM2:”. It features
a RS232 interface for controlling internal parameters like brightness and with special commands
control the unit externally. Please consult the separate documentation located at the link:
www.hatteland-display.com (support/accessories) for the SCOM interface.
Network INPUT/OUTPUT:
Supports 10/100Mbps Ethernet (LAN) and 10/100/1000Mbps Ethernet (GBLAN). Suitable for
twisted pair cables CAT.5E. Make sure the network cable connector ”clicks” into the RJ-45
connector.
RGB OUTPUT:
Will output a clone signal from the computer for use with external display or monitor. Connects via
a High Density D-SUB 15P Female connector. Fasten the cable to the connector using the
provided screws on the cable housing itself.
Connector area of panel computer
RGB OUT
Network GigaBitLAN & LAN
PCI SLOT 1
PCI SLOT 2
PS/2 Keyboard
Parallel (LPT)
COM4, COM2
COM3, COM1
PS/2 Mouse
USB 1,2,3
Compact Flash Reader
Power Input
NOTE: Available connectors / locations may vary depending on model !