Hatteland HM 20T07 MIL, Руководство пользователя

Страница: 18 / 78

18
IND100133-33
INB100005-8 (Rev 5)
Touchscreen (option)
Composite Video In
(1 x BNC)
RGB IN
(5 x BNC)
Power Input
Remote Control
1 or 2 x 9PDSUB
Physical Connections - HM MIL Models
Connection area of display (illustration)
COMPOSITE VIDEO IN (PAL/NTSC/SECAM VIDEO):
Connect your BNC cable connector (male) to the BNC Connectors (female) on the unit. This will allow a video signal
from i.e. cameras & dvd players to be visible on screen either as full screen video or Picture-In-Picture/Picture-By-Pic -
ture. To activate any of these functionalities, the unit must be configured via the OSD menus (see own chapter). PAL /
NTSC / SECAM VIDEO signal formats supported.
RGB IN: (RGBHV - Circular BNC connectors)
Connect your BNC cable to the 5 x BNC Connectors (female) connect the opposite to your equipment. Make sure the
connectors is firmly fasten and that you do not switch around the separate signal/colors for: R(to red color cable),
G(to green color cable), B(to blue color cable) H(to horizonal sync gray color cable) and V(to vertical sync black color
cable).
RGB OUT :
RGB OUT enables a direct clone of the incoming VGA (5 x BNC) signal. Connect the cable to the D-SUB 15P
Connector (female) and secure it to the hex spacers provided on the unit. Connect the other end to your equipment
and secure it.
TOUCHSCREEN: (optional)
This 9P COM connector provides touch screen communication for display units that have been equipped with a
factory mounted touch screen. It should be connected to a computer with touch screen drivers installed. See the touch
screen chapter in this manual for more information.
- Note that the connector is only installed upon customer request, and it will occupy 1 x DSUB connector from the
Remote Control functionality (see next page)
RGB OUT
( 1 x 15DSUB)