Hatco MVW Series, Инструкция по установке и эксплуатации, Страница: 7 / 24

OPERATION
English
Form No. mVWm-0515
7
General
Use the following procedures to operate a mini Vertical Warmer.
Read all safety messages in the Important Safety
Information section before operating this equipment.
Standard and approved manufacturing oils may smoke up
to 30 minutes during initial startup. This is a temporary
condition. Operate unit without food product until smoke
dissipates.
Startup
1. Plug the female end of the detachable power cord into the
power inlet on the back of the unit.
2. Plug the male end of the detachable power cord into a
properly grounded electrical receptacle of the correct
voltage, size, and plug configuration. See the
SPECIFICaTIONS section for details.
Plugging in the Unit
BURN HAzARD: Some exterior surfaces on unit will get
hot. Use caution when touching these areas.
3. move the Power I/O Switch (on/off) to the I (on) position.
The indicator light on the switch glows when the unit is on.
4. Turn the Temperature Control to the desired temperature
setting.
• Turning the control clockwise toward “7” increases the
temperature.
• Turning the control counterclockwise toward “1”
decreases the temperature.
NOTICE
WARNING
CAUTION
Power
Cord
Power
Inlet
Operator Controls
5. allow the warmer to preheat for approximately 30 minutes.
6. Lift the flip-up door and load pre-heated, pre-packaged
food product into the warmer.
Loading the mini Vertical Warmer
Shutdown
1. move the Power I/O Switch (on/off) to the O (off) position.
The indicator light on the switch will shut off.
Lift flip-up
door.
Load product
here.
Power I/O
Switch
Temperature
Control