Hatco MACHO NACHO FDWD-1-MN Series, Инструкция по установке и эксплуатации

Страница: 8 / 24

General
Use the following procedures to operate a macho Nacho
®
Chip
Warmer.
Read all safety messages in the ImPORTANT SAFETy
INFORmATION section before operating this equipment.
Startup
1. Plug unit into a properly grounded electrical receptacle of
the correct voltage, size, and plug configuration. See the
SPECIFICaTIONS section for details.
2. move the Power ON/OFF (I/O) switch to the ON (I) position.
3. Set the TEmPERaTURE Control to the desired temperature
setting.
4. allow 20 minutes to heat the cabinet to operating
temperature.
5. Open the upper door and fill the unit with chips.
BURN hAzARD: Some exterior surfaces on the unit will get
hot. Use caution when touching these areas.
Shutdown
1. move the Power ON/OFF (I/O) switch to the OFF (O)
position.
2. allow the unit to cool, and perform the “Cleaning” procedure
in the maINTENaNCE section of this manual.
WARNING
WARNING
FDWD-1-mN Controls
FST-1-mN Controls
POWER ON/OFF
(I/O) Switch
TEMPERATURE
Control
POWER ON/OFF
(I/O) Switch
CABINET TEMP
Monitor
TEMPERATURE
Control
Form No. mNm-0615
8
OPERATION
English