Form No. GRCMWDHHIM-0907
12
MAINTENANCE
LIGHT BULB REPLACEMENT
The display lights are shatter-resistant, halogen
light bulbs which illuminate the warming area. These
bulbs have a special coating to guard against injury
and food contamination in the event of breakage.
1. To replace a light bulb, disconnect the power
supply from the unit and wait until the unit has
cooled.
2. Remove the wire guard covering the bulb by
removing one screw on cover. (See Figure 12.)
3. Light bulbs have a threaded base. Unscrew the
light bulb from the unit and replace it with a new
specially coated halogen light bulb.
4. Re-install the cover. Make sure the wire rods are
engaged inside the holes on the reflector and
cover.
NOTE: Hatco shatter-resistant light bulbs meet NSF
standards for food holding and display areas. For
120 volt applications, use Hatco part number
WARNING
Only light bulbs which meet or exceed NSF
standards, specifically designed for food
holding areas must be used. Breakage of light
bulbs not specially coated could result in
personal injury and/or food contamination.
WARNING
If service is required on this unit, contact your
Authorized Hatco Service Agent, or contact the
Hatco Service Department at 800-558-0607 or
414-671-6350; fax 800-690-2966 or International
fax 414-671-3976.
WARNING
This product has no “user” serviceable parts. To
avoid damage to the unit or injury to personnel,
use only Authorized Hatco Service Agents and
Genuine Hatco Parts when service is required.
WARNING
Genuine Hatco Replacement Parts are specified
to operate safely in the environments in which
they are used. Some aftermarket or generic
replacement parts do not have the
characteristics that will allow them to operate
safely in Hatco equipment. It is essential to use
Hatco Replacement Parts when repairing Hatco
equipment. Failure to use Hatco Replacement
Parts may subject operators of the equipment to
hazardous electrical voltage, resulting in
electrical shock or burn.
Figure 12. Wire Guard Cover
