MAINTENANCE
Form No. GRpWSm-0610
10
General
Hatco Glo-Ray
®
pizza Warmers are designed for maximum
durability and performance with minimum maintenance.
ELECTRIC ShOCK hAzARD:
• Turn power switch OFF, unplug power cord, and allow
unit to cool before performing any maintenance or
cleaning.
• DO NOT submerge or saturate with water. Unit is not
waterproof. Do not operate if unit has been submerged
or saturated with water.
• Do not steam clean or use excessive water on unit.
• Do not clean unit when it is energized or hot.
This unit has no “user-serviceable” parts. If service is
required on this unit, contact an Authorized hatco Service
Agent or contact the hatco Service Department at 800-558-
0607 or 414-671-6350; fax 800-690-2966; or International
fax 414-671-3976.
Cleaning
To preserve the finish of the unit as well as maintain
performance, it is recommended that the unit be cleaned daily.
Submerging or saturating unit with water will damage unit
and void product warranty.
1. Turn off the unit, unplug the power cord, and allow the unit
to cool.
2. Wipe down all exterior and interior surfaces using a damp
cloth. a non-abrasive cleaner may be used for difficult
stains. Hard to reach areas should be cleaned using small
brush and mild soap.
3. Clean the side glass panels using a standard glass cleaner.
WARNING
NOTICE
Replacing Display Light Bulbs
Use only light bulbs that meet or exceed National
Sanitation Foundation (NSF) standards and are specifically
designed for food holding areas. Breakage of light bulbs
not specially coated could result in personal injury and/or
food contamination.
The display lights are incandescent light bulbs that illuminate
the warming area. Each bulb has a special coating to guard
against injury and food contamination in the event of breakage.
1. Turn off the unit, unplug the power cord, and allow the unit
to cool.
2. unscrew the light bulb from the unit and replace it with a
new, specially-coated incandescent light bulb.
NOTE: Hatco shatter-resistant light bulbs meet NSF standards
for food holding and display areas. For 120 and
120/208-240 volt applications, use Hatco part number
02.30.043.00. For 200, 220-230, and 230-240 volt
applications, use Hatco part number 02.30.058.00.
ELECTRIC ShOCK hAzARD: Use only Genuine hatco
Replacement Parts when service is required. Failure to use
Genuine hatco Replacement Parts may subject operators
of the equipment to hazardous electrical voltage, resulting
in electrical shock or burn. Genuine hatco Replacement
Parts are specified to operate safely in the environments
in which they are used. Some aftermarket or generic
replacement parts do not have the characteristics that will
allow them to operate safely in hatco equipment.
WARNING
WARNING
