Hatco Glo-Ray GRCSCL-24, Инструкция по установке и эксплуатации

Страница: 3 / 12

CAUTIONS
1. For safe and proper operation, the Carving
Station must be located a reasonable distance
from combustible walls and materials. If safe
distances are not maintained, discoloration or
combustion could occur.
CAUTIONS
1. Do not loosen the adjustment knobs more
than ½ turn. Doing so could loosen the
internal nut causing it to fall off, thereby
making the legs non-adjustable.
2. Use only non-abrasive cleaners. Abrasive
cleaners could scratch the finish of your
Glo-Ray Carving Station marring its
appearance and making it susceptible to soil
accumulation.
3. To avoid damage to cutting board do not
allow board to be immersed in water or run
through a dishwasher. Damage to cutting
board is not covered under warranty.
4. Only soft cleaning cloths should be used to
clean breath protector(s). Breath protector(s)
are made of shatterproof polycarbonate and
will scratch if proper care is not taken.
1
WARNINGS
1. Some exterior surfaces on the Carving Station
will get hot. Use caution when touching these
areas to avoid injury.
2. To prevent electric shock, always unplug the
Glo-Ray Carving Station before performing
cleaning or maintenance.
3. Plug warmer into an electrical outlet of the
correct voltage, size and NEMA designation.
If the plug and outlet do not match, contact a
qualified electrician to determine the proper
voltage and size and install the proper
electrical outlet.
4. Only bulbs which meet or exceed N.S.F.
standards, specifically designed for food
holding areas must be used. Breakage of bulbs
not specially coated could result in personal
injury and/or food contamination.
5. If service is required on this unit, contact your
Authorized Hatco Service Agent, or contact
the Hatco Service Department at 800-558-0607
or 414-671-6350; fax 800-690-2966 or
International fax 414-671-3976.
6. This product has no “user” serviceable parts.
To avoid damage to the unit or injury to
personnel, use only Authorized Hatco Service
Agents and Genuine Hatco Parts when service
is required.
7. Genuine Hatco Replacement Parts are
specified to operate safely in the environments
in which they are used. Some aftermarket or
generic replacement parts do not have the
characteristics that will allow them to operate
safely in Hatco equipment. It is essential to
use Hatco Replacement Parts when repairing
Hatco equipment. Failure to use Hatco
Replacement Parts may subject operators of
the equipment to hazardous electrical voltage,
resulting in electrical shock or burn.
8. Unit is not waterproof. DO NOT submerge in
water. Do not operate if it has been submerged
in water.
Form No. GRCSM-0401
IMPORTANT! Read the following important safety instructions to avoid personal injury or death,
and to avoid damage to the equipment or property.
IMPORTANT SAFETY INSTRUCTIONS