Form No. GRS2GM-0420
6
INSTALLATION
General
Glo-Ray 2-Go™ Heated Shelves are shipped with most
components pre-assembled. Care should be taken when
unpacking the shipping carton to avoid damage to the unit and
components enclosed.
WARNING
ELECTRIC SHOCK HAZARD: Unit is not weatherproof.
Locate unit indoors where ambient air temperature is a
minimum of 70°F (21°C).
FIRE HAZARD
: Locate unit a minimum of 1″ (25 mm) from
combustible walls and materials. If safe distances are not
maintained, combustion or discoloration could occur.
1. Remove the unit and any loose components from the
carton.
NOTE: To prevent delay in obtaining warranty coverage,
complete online warranty registration. See the
IMPORTANT OWNER INFORMATION
section for
details.
2. Remove tape and protective packaging from all surfaces
of unit.
NOTICE
Do not lay unit on the front or back side. Damage to the
unit could occur.
3. Carefully lay the unit on its side and install the included
four legs.
CAUTION! This step requires at least two
people.
• Thread a leg into the hole at each corner on the bottom
of the unit. Hand-tighten the legs until snug—do not
over-tighten.
NOTE: Legs are not required on GRS2G-3920-2 and
GRS2G-3920-3 models if installing on a countertop
and sealing with silicone.
4. Place the unit in the desired location.
• Locate the unit in an area where the ambient air
temperature is constant and a minimum of 70°F
(21°C). Avoid areas that may be subject to active air
movements or currents (i.e., near exhaust fans/hoods,
air conditioning ducts, and exterior doors).
• For floor units, make sure the floor is level and the unit
is in an area convenient for use.
• For countertop units, make sure the countertop is level
and strong enough to support the weight of the unit and
its contents.
5. Secure the unit using the wall brackets or floor flanges, if
necessary.
• GRS2G-3920-2 and GRS2G-3920-3 models are counter
mountable and can be secured to the countertop or a
wall to prevent tipping.
• GRS2G-3920-4 and GRS2G-3920-5 models are
recommended to be secured to the floor or a wall to
prevent tipping.
WARNING
Units not installed properly could tip over, resulting in
personal injury and/or damage to unit.
• For securing the unit to a wall using the wall
brackets, refer to the “Wall Bracket Installation”
procedure in this section.
• For securing the unit to the floor/countertop using the
floor flanges, refer to the “Floor Flange Installation”
procedure in this section.
Wall Bracket Installation
Use the following procedure to secure a unit to a wall using the
wall brackets.
1. Verify that the desired installation location will work for
securing the unit.
2. Locate the studs in the wall to determine the appropriate
fasteners for proper installation (not supplied).
3. Secure the unit to the wall using the appropriate fasteners
through the wall brackets.
Wall Bracket
Wall Bracket Installation
