
Form No. FM2SSM_CN-0810
7
OPERATION
English
TEA Button
................Press the TEA Button to toggle through
and select one of four different preset
tea modes.
UP Button
..................Press the uP button to increase a
setting.
DOWN Button
............Press the DOWN button to decrease a
setting.
Figure 6. FM2SS-7 Control Panel
Brewing Coffee or Tea
use the following procedure to brew coffee or tea.
1. Rotate the cover locks to the unlocked position and remove
the top cover.
2. Remove the coffee/tea basket, spreader cover, and
pumping tube assembly from the tank.
Make sure a minimum of 2 liters (0.5 gallons) of water is in
unit before plugging in or operating. Operating unit with
less than 2 liters (0.5 gallons) of water will cause unit to
overheat.
Use only cool water when filling unit.
3. Fill the tank with cool water to the desired cup level. Cup
level markings are located on the front liquid level tube.
NOTE: The unit makes 2.3–7.0 liters (13–40 servings) of
brewed coffee or tea. DO NOT overfill or underfill the
unit. Fill according to the markings on the liquid level
tube for the number of cups desired. One serving
equals 0.24 l (five fluid ounces) of brewed coffee or tea.
4. Moisten the coffee/tea basket to keep small particles from
sifting through.
5. Add the desired amount of ground coffee or tea to the
coffe/tea basket (for coffee, refer to the “Coffee Brewing
Chart”). The amounts can be varied to suit taste.
6. Insert the top of pumping tube assembly up through the
bottom hole of the coffee/tea basket. Cover the coffee/tea
basket with the spreader cover.
7. Hold the top end of the pumping tube assembly and place
the tube with the coffe/tea basket into the unit. Make sure
the bottom of the pumping tube assembly is positioned
properly in the center of the tank inside the percolation well.
NOTICE
HEATING
Indicator
POWER
Button
READY
Indicator
COFFEE
Button
UP
Button
DOWN
Button
TEA
Button
BOIL
Button
TEMPERATURE
Display
General
use the following procedures to operate a FLOW
MAX
Coffee
and Tea Brewer.
Read all safety messages in the IMPORTANT SAFETy
INFORMATION section before operating this equipment.
BURN hAzARD:
• Some exterior surfces on unit will get hot. Use caution
when touching these areas.
• Make sure cover is securely in position before starting
brew cycle. hot water and escaping steam may cause
scalding injury during the brew cycle.
• Do not move or relocate unit when it contains hot
liquids. Turn off unit and allow to cool completely
before moving or cleaning.
1. Clean the entire unit inside and out before using for the
first time. See the MAINTENANCE section for cleaning
instructions.
2. Read the “Control Panel” section to learn about the
controls.
3. Go to the appropriate procedure in this section for the
desired hot beverage. For coffee or tea, see the “Brewing
Coffee or Tea” section. For hot water, see the “Heating
Water” section.
Control Panel
use the following section to learn about the functions of the
controls on the control panel.
hEATING Indicator
...The HEATING indicator (red) is on
during the brewing/heating cycle. The
HEATING indicator will turn off when
the brewing/heating cylce is complete.
READy Indicator
.......The READy indicator (green) will turn
on when the brewing/heating cycle is
complete and the unit is ready to serve.
The unit will hold the hot beverage at
the selected temperature.
TEMPERATURE
Display
.......................The TEMPERATuRE display shows
the current temperature of the unit. It
also shows the tempertature setpoint
and
mode
selections
during
programming as well as error codes
(see the MAINTENANCE section for
error code information).
POWER Button
.........Press the POWER Button to turn on
the unit and start a brewing/heating
cycle. When the unit is on, press the
POWER button to turn off the unit.
BOIL Button
..............Press the BOIL Button to select water
heating mode. use the uP button and
DOWN button to set the desired
temperature within a range of 50–95°C
(122–203°F).
COFFEE Button
........Press the COFFEE Button to toggle
through and select one of three
different preset coffee modes.
CAUTION
WARNING
Содержание FM2SS-7 Series
