5
When powering the camera ON for the
first time
the camera will take you through the
initial
camera setup.
Powering the Camera ON
1)
Batteries
Make sure the batteries have been inserted properly into your digital camera, according to
the polarity shown inside the battery compartment.
Use 2 x AAA (1.5V) batteries. Alkaline batteries are recommended. (Batteries not included.)
- Using a screw driver (not included) loosen the screw on the bottom of the battery
compartment cover and remove the cover.
- Make sure the batteries are inserted with the correct polarity, as indicated on the inside of
the battery compartment.
- Close the battery compartment cover and tighten the screw securely.
When the “No Power” is displayed on the LCD, this indicates that your camera has
insufficient battery power and will automatically power off. If you have captured sample
images on the camera’s memory, you will need to download the sample photos and videos
to your PC. If there is no SD card inserted before it powers off, the photos and videos will not
be saved.
Note:
Remove the batteries from the camera when not in use for an extended period.
Do not mix alkaline and non-alkaline batteries.
Some features, such as Flash, will not work if the battery power level is low.
When the battery power is low the battery icon turns red and the camera will
automatically turn off a few seconds later.
Rechargeable batteries not recommended.
The energy status of the power is displayed on LCD as shown below:
Full battery power
Medium battery power
Low battery power
