How to replace batteries
4x l.SV C Alkaline Batteries
l
Locate the battery compartment under the
fabric fastener on the underside of the pup.
2
Use a Phillips/cross-head screwdriver
(not included} to loosen the screw in
the battery compartment cover.
3 Remove the cover and the batteries.
Discard the old batteries.
4 Replace with 4 new 1.5 volt C-size
alkaline batteries.
5
Replace the cover and tighten the screw.
6
Be sure to have the power switch in the ON
or MUTE position.
7
Close the fabric flap on the underside of the pup.
IMPORTANT: BATTERY INFORMATION
Lt.
CAUTION:
1. TO AVOID BATTERY LEAKAGE
a. Always follow the instructions carefully. Use only batteries specified and
be sure to insert them correctly by matching the + and - polarity markings.
b. Do not mix old batteries and new batteries or standard (carbon-zine)
with alkaline batteries.
c. Remove exhausted or dead batteries from the product.
d. Re move batteries if product is not to be played with for a long time.
e. Do not short-circuit the supply terminals.
f. RECHARGEABLE BATTERIES: Do not mix these with any other types of batteries.
Always remove trom the product before recharging. Recharge batteries under
adult supervision. DO NOT RECHARGE OTHER TYPES OF BATTERIES.
2. Should this product cause, or be affected by, local electrical interference, move it
away from other electrical equipment. Reset (switching off and back on again or
removing and re-inserting batteries) if necessary.
Troubleshooting
lf your pup stops werking:
l
Try switching the pup off and then back on again.
2
lf switching the pup off and on again does not work, follow the
directions above to replace the batteries in your pup.
(See battery insertion diagram.)
