HARVEY HW615, Инструкция по эксплуатации, Страница: 8 / 41

5
4.3 Power Supply
Electrical connections must be made by a qualified electrician in compliance with all
relevant codes. This machine must be properly grounded to help prevent electrical
shock and possible fatal injury.
The band saw is factory wired for 230 volts and its
operating amp rating is 10 A. It is recommended that
the band saw be connected to a grounded and
dedicated 20 amp circuit with a 20 amp circuit
breaker or time delay fuse. Local codes take
precedence over recommendations.
4.4 Grounding
This tool is equipped with an electric cord having an
equipment-grounding conductor and a grounding
plug. The plug must be plugged into a matching outlet
that is properly installed and grounded in accordance
with all local codes and ordinances. Do not modify the
plug provided. If the plug will not fit the outlet, have
the proper outlet installed by a qualified electrician.
4.5 Extension Cords
Use Table 1 as a general guide in choosing the correct size cord. The smaller the gauge
number, the heavier the cord. If in doubt, use the next heavier gauge.
Recommended Gauges (AWG) of Extension Cords
Table 1
Ampere rating Volts Total length of cord in feet
120 25 50 100 150
240 50 100 200 300
More than Not more than Minimum gauge cord
0 6 18 16 16 14
6 10 18 16 14 12
10 12 16 16 14 12
12 16 14 12 NR NR
NR: Not Recommended.
4.6 Dust Collection
The use of a dust collection system is strongly recommended for this band saw. It will help
keep the shop clean, as well as reduce potential health hazards caused by inhalation of
wood dust. The collector should have a capacity sufficient for this size machine – 400 CFM
is recommended.