HARVEY ALPHA HW110LC-36P, Инструкция по эксплуатации

Страница: 18 / 41

15
5.4.8 Install the blade guard
1. Slide the knurled knob out (refer to Fig. 16) and
rotate it forward so it engages the upper bracket.
Fig. 16
2. Slide the blade guard spreader all the way down
into the block, then rotate the knurled knob so it
disengages the bracket and the locking pin
engages the hole in the center of the spreader.
3. Fig.17 (A) shows the blade guard, meeting the
UL62841 standard, is suitable for the North
American market.
Fig.17 (B) shows the blade guard
meeting the CE standard. For different markets,
the machine is equipped with different blade
guards, please refer to the chapter “
3. Machine
Description ” for detailed information.
Fig. 17
Check if the saw blade is tightened before
operating the machine.
Give the spreader an upward tug to verify if it is
locked in place.
5.4.9 Extraction system
A dust collection device should be used by the
customer
，
the dust extraction equipment must
be switched on before commencing machining.
Fit the over arm to the rear rail ( Fig.18 ):
1. Fit the bracket (A) to the rear rail with screw B.
2. Fit the over arm to the bracket (B) with clip (C).
(Total 2 sets of clasps)
3. Connect the pipe (1.5”) provided by us to the
dust outlet as fig point.
Note: The mounting hardware of the dust outlet is
pre-mounted on the cabinet.
Fig. 18
Requirements for the dust collector:
1. Required air flow: 470 CFM (800 m³/h).
2. Ensure pressure drop of each dust collector
outlet carrying air current speed: 1100Pa
3. Dry chips: 3937 FPM (20 m/s).
4. Wet chips: 5511 FPM (28 m/s). (water content
is equal to 18%)
5.4.10 Motor cover installation
Install the motor cover by inserting the door pins
into the hinge sockets on the cabinet as shown in
Fig. 19.
Fig. 19