!
3K Transport Procedure
_
1. Clear the area of bystanders, especially children.
2. Always transport conveyor in full down position. The lift arm of undercarriage
should be seated against the transport saddle with slight tension on the winch cable
and at least three complete wraps of cable around the winch drum.
3. Make sure the hitch pin or bolt is securely attached and an additional safety chain is
secure to the conveyor and tow vehicle.
4. Do not transport in excess of 20 mph (32 km/h). Comply with all local regulations
governing marking, towing, and maximum width.
5. Be alert to overhead obstructions and electrical wires. Electrocution can occur
without direct contact with power lines.
6. Never allow anyone to stand underneath or ride on the conveyor while it is
transported.
7. Transport conveyor with hopper in collapsed position to avoid damage from rocks.
8. Always remove gas tank from machine during transport.
!
4. Service
4A Fluids and Lubricants
_
1. Use an SAE multipurpose high temperature grease with extreme-pressure (EP) rating. Also
acceptable is an SAE multipurpose lithium based grease.
2. Your machine can operate at top efficiency only if clean lubricants are used. Use clean
containers to handle all lubricants. Store them in an area protected from dust, moisture,
and other contaminants.
4B Lubrication
_
1. Use the provided checklist to keep a record of all scheduled maintenance.
2. Use a handheld grease gun for all greasing.
3. Wipe fittings clean before greasing to avoid injecting dirt and grit.
4. Repair and replace broken or missing fittings immediately.
5. If fittings will not take grease, remove and clean thoroughly. Also clean lubricant
passageway. Replace fitting if necessary.
!
18
Содержание FC1535
Страница 8: ... Figure 2 Transport Safety Zones 8 ...
Страница 39: ... 39 ...