24
7. Installation of Moisture Sensor Pads and Disks
a. Open rear tail gate of baler and lock in the up position. Refer to baler manual on how to lock
door open.
b. Remove bale shaping discs on each side of chamber by grinding welds. Once removed grind
any remaining welds so sides of bale chamber are smooth.
c. Place plastic isolator (006-4641FX) in the same spot that the shaping disc had. There should
be a hole in the baler that matches up with the hole in the plastic isolator. If not, use the
isolator as a template and mark the hole. Center punch the hole and drill it to
¾” (Note: before
drilling make sure you are not drilling into sensitive equipment on the outside of the baler). Drill
through the complete square tube. About two inches. Repeat for other side of the baler.
d. Insert plastic bushing (006-4641G) from the outside of baler. Make sure it is flush with the
outside of the baler frame. Go to the inside of the baler and mark amount that protrudes into
the chamber. Remove and cut off excess material. Repeat for other side.
e.
Using 4” carriage bolt slide the parts on in following order: metal disc (001-4641HX), plastic
isolator (006-4641FX) and shortened plastic bushing (006-4641G).
f.
Insert disc assembly into 3/8” hole from inside of bale chamber. Secure to outside of baler by
attaching to the protruding carriage bolt in the following order: small isolator (006-
4641), ½” D
shaped washer, ½” lock washer, ½” jam nut. Tighten down and repeat for the other side.
Make sure no part of the bolt or hardware makes contact with the frame of baler-no metal to
metal.
g. Route moisture harness (006-4640G3E) from processor down to the carriage bolt on each
side. Make sure it does not come in contact with any moving parts. Secure with cable ties.
h. Attach moisture cable to moisture carriage bolt by placing items in the following or
der: ½” D
shaped washer, Ring terminal of moisture harness (006-4640G3E
), second ½” D washer, ½”
lock washer, ½” Jam Nut. Tighten down and repeat for other side. Make sure none of the
hardware comes in contact with the frame of the baler.
Содержание 547C
