Hartridge HM1023, Инструкция по эксплуатации и обслуживанию

Страница: 8 / 20

HM1023 (AE72) Operating and Servicing Manual HARTRIDGE LIMITED
6 HL078 (EN), Issue 1, AT3376, 04/2018
Gloves conforming to standard BS EN 407:1994 must be worn when handling parts
after testing which may be hot.
Safety footwear must be worn in the test area at all times. Injury to the feet may be
sustained in the event that equipment under test is dropped (during loading or
unloading).
Accidents can occur to unauthorised personnel during testing. Untrained person(s)
must not be present in the test area when the equipment is operating. Only qualified
personnel are to use this equipment.
This equipment contains electrostatic sensitive devices. Observe the necessary
precautions for handling electrostatic discharge sensitive devices. Do not touch printed
circuit boards and associated electronic connections and components.
There must be no naked flames. Smoking in the vicinity of the equipment is strictly
forbidden. Potentially flammable vapours are present in the test stand and ignition is
possible although unlikely.
Severe injury can be caused by slipping on spilt oils or fluids. All spillage of fluids in the
test area must be dealt with immediately.
Arc welding equipment must not be operated within 5 metres of the host machine . The
electrical supply to welding equipment must be provided from a remote isolating
transformer. Arc welding can disturb the electronics.
Ensure that the servicing requirements and intervals as set out in the Maintenance
section are adhered to. Operate and service this equipment only if competent to do so..
Use fluid of the correct specification only. Obtain the manufacturers Health & Safety
Data Sheets and follow the advice given therein. Prolonged and repeated contact with
oil products, ingestion or excessive and prolonged inhalation of oil mists can be
detrimental to health. Use an appropriate barrier cream.
Do not adjust the dump valve air pressure regulator on the host machine, this is pre-set
and locked off prior to leaving Hartridge. If this is adjusted after leaving Hartridge by
unauthorised personnel, it will invalidate the warranty and may cause serious injury.
All injector electrical connectors not in use should be stowed away to prevent any
damage to connectors.