Hartmann DS5, Инструкция по эксплуатации

Страница: 3 / 17

Installation instructions - Free-standing model
Turn
2
3
4
Once the appliance is positioned , adjust the feet
(screwing them in or out) to adjust the height of the
dishwasher, making it level. In any case ,the appliance
should not be inclined more than 2
.
°
During levelling ,unplug the appliance from the mains.
Drain pipe
connector Inlet pipe
connector
BACK VIEW
produce dimensions 1
( All sizes are given in millimetres)
850mm H x 580mm D x 600(or 450)mm W
We reserve the right to make technical
modifications.
600
850
3/4”
1/2”
3/4”
3/4”
MIN 10 mm
P=30-1000KP
POWER OUTLET
Connect the cold water supply hose to a threaded 3/4(inch)
connector and make sure that it is fastened tightly in place.
If the water pipes are new or have not been used for an
extended period of time, let the water run to make sure that
the water is clear and free of impurities. If this precaution is
not taken, there is a risk that the water inlet can get blocked
and damage the appliance.
The water supply to the appliance can also be connected to the
house hot water line (centralized system, heating system),as
long as it does not exceed a temperature of 60 °C.
In this case, the wash cycle time will be shortened by about 15
minutes and the wash efficiency slightly reduced.
The connection must be made to the hot water line following the
same procedures as those for the connection to the cold water
line.
The plug must be plugged into an appropriate
outlet that is installed and grounded in accordance
with all local codes and ordinances.
Inlet pipe connection
6
Insert the plug
The first time you use the dishwasher , check the water inlet hose and drain hose for leaks.
Inlet pipe
connector
Drain pipe connector
POWER
OUTLET
SINK
DISHWASHER
Mi n 100mm
Insert the drain hose into the drain pipe and fixed properly with a clamp . Make
sure thereis no bending on the drain pipe ( You may use the special plastic
support that attached with the appliance).The free end of the hose must be
at a height between 400 and 1000mm and must not be immersed in water.
Drain pipe connection
5
FRONT VIEW
Min 100mm
FRONT VIEW
Inlet pipe connector
Drain pipe connector
POWER
OUTLET
SINK
DISHWASHER
Min 100 mm
Please refer to above picture, if you want
to install the dishwasher at the right side
of the sink.
NOTE :
1