3
Parts list
- 1 set of bend guides A LH and RH
- 1 set of bend guides B LH and RH
- 1 carriage unit + side cladding
- 1 chain frame + 4 screws
- 1 mattress
- 1 drive unit
- 1 SB - drive 1.2
- 1 SB - drive 1.1 with yellow dot
- 1 synchronous shaft + 2 couplings
- 1 c hand - held
emergency lowering
- wooden slats as required
- 12 hardness adjusting slides as required
- 2 stops retraction / extension
- 2 x 2 guide rails
- 8 ventilation rings
- 1 metal feet with rollers for the front plate
- 2 belts
- 2 belt holders
- 4 belt hooks
- 4 plastic plugs
A
B
Hand held switch
to initialize
- push the buttons A + B at the same time and hold.
- the drives retract the system and stop at the end position.
- there is sounding a beep for successful operation.
regular service
Button A
Reclining area is retracted. Press button until the desired position is reached.
Button B
Reclining area is extended. Press button until the desired position is reached.
ATTENTION!
In case of a power failure, you can extend the system by pressing
the button (*) on the emergency lowering.
After that the control system needs an additional teach-in run!
Do not extend the bed completely in case of a power failure, as the system
may otherwise be damaged.
Only extend and retract the bed while unloaded!
The system is protected against malfunctions and improper handling by an
integrated overload protection in the controls.
After twice run in / out service to take a break time of 18 minutes is required
to prevent the drive motors from overheating!
*
