Uncontrolled when printed
–
Version 2
2.
Next, you should rivet the pole into the centre pocket of the sheet from underneath, riveting
through the line of black PVC tape into the Centre Pole. Rivets should be fitted at even
intervals keeping to a rough guide of 30cm / 1 foot per rivet. Place a final rivet on the very
end of the centre pole pocket on the top of the sheet through the black PVC tape.
3.
For ease of installation we recommend rolling
the sheet up before lifting onto the apex’s.
Also, ensure the sheet is the correct way around for the desired fixing side.
4.
Draw a horizontal line along the body top rail of the vehicle to be used as a sheet fitting
guideline. If the rail is flat then y
ou should mark 2” down. If the rail has a taper you should
mark 5” down including the capping.
5.
Fix
the sheet along the line using tek bolts. This should start at 1½” from the front of the
front apex.
6.
The sheet stops should now be fitted at 14” from the
front, in the centre (if applicable) and
14” from the
rear.
