RUG-052/199/200/201/210/211/212
Aluminium Rugby Posts
Code:
Product:
1
Dig holes 1100x1100x1000 deep at centres of
5
mm as shown in Fig 2. Concrete the sockets in
leav approx
0mm from top of concrete to
ground level (to replace turf . Use a spirit level to make sure that the
sockets are truly vertical and support until set. Replace the turf
extracted when the concrete has cured (allow concrete to set before
moving on to step 2).
Install Sockets
Prepare Hinge Adaptors
-
676
25mm below
ground level and
e
10
)
(if applicable) - Add 1 Hinge Bolt,
Nut and 4x Nylon Washers to the back of the Hinge Adaptor as
shown in Fig 3, and insert the Hinge Tube into the Socket. Leave
the Hinge open with the Top Tube facing in towards the pitch as shown
in Fig 4.
2
3
Prepare the Uprights
- Slide the Bottom Uprights into the Hinge
Assemblies (if applicable). Position the Bottom Uprights with the
Crossbar Channel facing inwards, as shown in Fig 4 and slide the Top
Uprights into the Bottom Uprights (if applicable). Additionally, for 6 & 7m
posts, fit the cap over the top of the Upright from fittings pack FPK741.
4
Raise the Uprights
Do not let go of posts until all bolts are secure
Fit the Crossbar
- lift each post (one at a time) into the vertical
position and for non-hinging posts: drop the bottom upright into Socket.
For hinging posts: slide the Safety Bolt with Washer through the hinge
assembly and secure with a Washer and Nylock Nut, as shown in Fig 5.
Finally, bolt the hinge plates together with 4x M14 bolts and washers as shown
in Fig 5 & 6.
. Repeat for
second post.
- Using a step ladder at each post, lift the crossbar into
position and securely bolt it to the top of the channel attached to the
uprights with the fasteners supplied with the crossbars, see detail in Fig
4.
5
Assembly Instructions
Fig 5
Fig 2
5676mm
1100
900
25
100
ADDITIONAL MAINTENANCE:
For smoother operation and to prevent rust, periodically grease hinge.
Safety
Bolt
Washer
M14 Bolt
Nylock
Nut
Fig 6
Nylon
Washer
Safety
Bolt
Fig 3
Nylock
Nut
Fig 4
Fit Crossbar
after Uprights
Use Fittings Pack
To Attach Crossbar
To Upright FPK710
