ASSEMBLY INSTRUCTIONS FOR FBL-167 - PVC FUTSAL GOAL
1.
PLEASE NOTE:
Before assembling the goal layout all the parts on the ground where you intend to
assemble the goal so that you can make sure that all the parts are present and correct.
All connector parts have button clips already inserted into them. When assembling the goal, gently
squeeze the button clips down low enough to slide the tubes over them. Then make sure that the button
clips are inserted into the holes provided on the tubes. This will make sure that the tubes are fastened
together correctly.
1
6
5
5
6
2
3
2.
Assemble the crossbar by inserting the corner connectors (1 & 2
PLP115/116) into the large crossbar connector (6 PLA111), now insert connector (5 PLP107) into
each end then join up the rest of the cross bar using (3 PLP090).
CROSSBAR ASSEMBLY:
7
7
17
5
18
5
17
MAKE SURE ANCHOR LABELS ARE ON THE END
3.
Assemble the backbar by inserting the corner connector (7 PLA110) into
the backbar tube (17 PLP089) making sure that the label is at the same end as the corner joint. Now
insert connector joint (5 PLP107) into the end of each part then connect all together using (18 PLP121)
BACKBAR ASSEMBLY:
H
A
R
R
O
D
6
5
4
4.
Assemble the upright by inserting connector (5 PLP107) into the bottom
upright (6 PLA111), to complete the upright insert (4 PLA086) onto (5 PLP107) do this for both sides.
NOTE. Make sure that Harrod sticker is facing the correct way up as shown in diagram above.
UPRIGHT ASSEMBLY:
Label
Button Clip
Button Clip
