Harrison Mixbus VBM, Руководство пользователя

Страница: 40 / 67

MIXBUS VBM 2 December 2021
2.4.1.2 Redirect Section
The Redirect section provides for inserting processing plugins and additional sends out of the
bus strip. The functioning of this section is identical to that in the Input channel strip, as covered
in Section
2.2.2 .
2.4.1.3 Program Bus Signal Processing
Clicking on the "VBM Strip" button on any input channel or bus master displays the signal
processing sections on all input channel strips and buses.
The signal processing available on the on buses is slightly different than that on the Input
strips. Figure 30 shows the bus signal processing detail.
Figure 30 : BUS SIGNAL PROCESSING
The bus signal processing provided is as follows.

Leveler: The Leveler is a compressor with a low fixed ratio and release time. It is
designed to gently smooth out the peaks in a wide range of signals. The slider on the
left adjusts the limiting threshold from 0 dB to -40 dB. The Attack knob sets the attack
time over a range of 4ms to 100 ms. The Gain knob provides makeup gain over a range
0dB to 20 dB. The "Lvl" button turns the processing on and off. The meter bar indicates
the instantaneous amount of gain reduction.

Equalizer: The 3 band equalizer operates over the following ranges:
o
LOW: +/-15 dB boost/cut shelving response, 125 Hz corner frequency
o
MID: +/-15 dB boost/cut bell response, 900 Hz centre frequency
o
HI: +/-15 dB boost/cut shelving response, 3200 Hz corner frequency
40